Reading Tags with the ChameleonMini Rev.G

January 06, 2017

These step by step instructions cover how to read an HF Tag (13.56 MHz) with the ChameleonMini Rev.G. 

What you will need:

Take a look at the Getting Started Guide if you need help with the setup process.

1. Connect up your ChameleonMini and start the client.

CMini Rev.G Hookup

2. Inside your client enter the following command to configure the ChameleonMini as a reader. 

Config=ISO14443A_READER

Output:

100:OK=ISO14443A_READER

3. Place tag near the ChameleonMini. Run the read command.

GETUID

Outputs:

Mifare Ultalight

101:OK WITH TEXT
041891EA453181

Mifare 1K

101:OK WITH TEXT
5C9F9F0D

Mifare 4K

101:OK WITH TEXT
FE333A53

Mifare Desfire EV1

101:OK WITH TEXT
04113B624D3C80





Also in Blog

Making a Physical Mifare 1K UID Clone
Making a Physical Mifare 1K UID Clone

January 10, 2019

Follow these steps to learn how to use a Chinese Magic Card 1K to make a Physical Mifare 1K UID clone. This blog is using a Proxmark3 running firmware V3.0.1.

View full article →

Making a physical HID Prox 2 Clone - Firmware V3.0.1
Making a physical HID Prox 2 Clone - Firmware V3.0.1

January 10, 2019

Follow these easy steps to make a physical HID Prox 2 clone using the Proxmark3 with firmware V3.0.1.

View full article →

Making a physical EM4100 Clone - Firmware V3.0.1
Making a physical EM4100 Clone - Firmware V3.0.1

January 10, 2019

Follow these steps to make a physical EM4100 clone using the Proxmark3 firmware version 3.0.1.

View full article →